Quote:
Originally Posted by dlfrisch
I have a mixture of grease fittings. I have trouble using the standard Model A fittings even with the proper grease fitting end. I would like to remove the existing factory fittings and install new Zerk type fittings. How do I do it. The factory fittings are not wrenchable and I can’t seem to get snap-on wrench on them.
|
I bought a replacement zerk kit from one of the vendors, but many of the “hammer in” replacement zerks are too large for the car. The threaded zerks worked fine for the holes that are threaded.
I still have this issue too.
Sent from my iPhone using Tapatalk