View Single Post
Old 10-31-2011, 01:03 AM   #4
Dan Partain
Senior Member
Dan Partain's Avatar
Join Date: May 2010
Location: Hangtown, CA
Posts: 500
Default Re: wrong front cross member

I had a reproduction front crossmember that I purchased in the late 70's that fit like that, if I remember correctly it was made in Argentina. It looked good but the holes weren't right and I didn't want to start a project by filling the holes and re-drilling out the crossmember.

I decided not to use it and eventually found an NOS crossmember that fit perfectly.
Dan Partain is offline   Reply With Quote