Thread: GAV leaking
View Single Post
Old 08-19-2020, 03:00 PM   #4
Senior Member
ryanheacox's Avatar
Join Date: Apr 2013
Location: Northwest CT
Posts: 1,051
Default Re: GAV leaking

You want the gas level ~5/8" below the gasket, some like 15/16". A good rule of thumb is to have the seam of the float at an even 1" from the casting with the upper half flipped upside down. This info is all for the Zenith. You also want the cap jet to have a depth of 7/16" from the machined surface of the lower half and the main jet to have a depth of 3/8".
ryanheacox is offline   Reply With Quote