View Single Post
Old 07-26-2020, 09:48 AM   #13
Senior Member
katy's Avatar
Join Date: Jun 2015
Location: Alberta, Canada
Posts: 3,012
Default Re: Decided to pull the motor/trans

I can't think of any way that a cylinder can wear that much and not leave a ridge.
Model T's do that, the top ring comes right to the top of the cylinder w/the piston sticking up above the block. Maybe the pistons you removed are like that?

I already removed the taper and brought the cylinders to 4" (the pistons mic 3.998). well, 3 are done, one to go.
Is .002" piston clearance enough on these engines?
Play it again Sam.

Last edited by katy; 07-26-2020 at 09:49 AM. Reason: Corrected typo
katy is offline   Reply With Quote