View Single Post
Old 07-25-2020, 06:46 PM   #10
Licensed to kill
Senior Member
Licensed to kill's Avatar
Join Date: Aug 2016
Location: Alberta
Posts: 925
Default Re: Decided to pull the motor/trans

Tore the tranny down. Gears are rounded on the tips and one tooth on one (don't recall which one) has a small chip. Not sure what to do there. $1000 for all new guts for a car that will see MAYBE 1000 miles a year???. Trans works well but would jump out of second when pulling. Hate to put it back together as is but...........I've got tomorrow to ponder and look them over again. Interesting note, Rather than two roller bearings and a spacer in the cluster it had three roller bearings. two short and one long. Also, rather than snap rings to hold the main bearings, there is a ridge cast into the case. Sure this is a model year thing just don't know enough about these to know what year.
Licensed to kill is offline   Reply With Quote