Quote:
Originally Posted by KR500
Tim, I own a kwik way model F. So you know there are two models of the F, one with a cutter setting micrometer done off the bar and one where the micrometer is inserted into the bar to set the cutter. I purchased my bar about 20 years ago and it has seen only a dozen or so engine blocks bored. I do want to try my hand at sleeving a block back to standard. PM me for my contact info. Dan
|
I also have an Kwik-Way F, but I have never used it. I purchased it as a spare, and now after what Dan has said, I should probably look at mine along with the tool kit to see just how the tool in my F is set.
Kwik-Way was about like Ford in they made similar models and used different letters of the alphabet to differentiate. I know they made the F, the FL, FN, FR, FS, FT, and likely several others that I am forgetting. I also included a couple pictures of my red FR unit that has served me well. I wish I knew what the differences were between all of the different models.
.