The Ford Barn - View Single Post - 3-brush gen problems

hotcoupe · 07-25-2021, 08:31 AM

I had a similar problem with my '37 1/2 ton, i installed an electronic regulator inside the generator case (the field brush will need to be removed). It works FLAWLESSLY. I found this unit through an internet search, designed and constructed by an electronics engineer, i think he's located in Ohio.
Hope this helps,
Tom
P. S. I believe the Fun Products unit is a diode type cut out with a heat sink, the unit that i installed provides full regulation and can be used with the Fun Products unit.
T. W.

07-25-2021, 08:31 AM	#5
hotcoupe Senior Member Join Date: May 2010 Location: imperial,mo Posts: 694	Re: 3-brush gen problems I had a similar problem with my '37 1/2 ton, i installed an electronic regulator inside the generator case (the field brush will need to be removed). It works FLAWLESSLY. I found this unit through an internet search, designed and constructed by an electronics engineer, i think he's located in Ohio. Hope this helps, Tom P. S. I believe the Fun Products unit is a diode type cut out with a heat sink, the unit that i installed provides full regulation and can be used with the Fun Products unit. T. W. Last edited by hotcoupe; 07-25-2021 at 08:42 AM.