The Ford Barn - View Single Post

Bill OH · 10-22-2020, 06:12 PM

I drilled my bushing many times with 1/8th inch bit and took it out in pieces and the crumbs I sucked out by placing the hose down over the shaft. I installed a wheel barrow bearing - perfect fit - the bearing has a flange on it. Your hardware can supply the bearing.

10-22-2020, 06:12 PM	#8
Bill OH Senior Member Join Date: May 2010 Posts: 426	Re: Removing upper steering shaft grommet I drilled my bushing many times with 1/8th inch bit and took it out in pieces and the crumbs I sucked out by placing the hose down over the shaft. I installed a wheel barrow bearing - perfect fit - the bearing has a flange on it. Your hardware can supply the bearing.