Quote:
Originally Posted by Mart
Tubs, would it be worth "claying" that plug on an engine to check for clearance to the valve?
I guess it would be a good idea when trying any plugs that protrude past the head surface.
Mart.
|
I really don't have anything set up at the present time, so that's probably not in the cards. I do have several stock cylinder heads with H10's installed, so I'll give them a look and maybe take some pictures. IIRC, the stockers stick out just about the same amount. Since I am not into wild cams, that's good enough for me.
One should probably do this kind of checking when installing any non-stock setup.