Quote:
Originally Posted by thebanjoman
Turns out I am not as far along with the body wood as I thought.
It appears that the fittment for the wood is too large for the side windows.
There is about a 3/8" air gap on both pieces that I have to figure out fitttment.
Should I cut the "C" and remove a section out of the center? I know these need to fit better than they are.
Suggestions?
|
Hallelujah.
I went looking back over some old data I had and turns out i still had some photos of the original wood installed. I thought they were lost for good.
I had the wood placed wrong, according to my photos and I'm back on track.