The Ford Barn - View Single Post - Crankshaft pulley

Pete · 03-28-2021, 06:08 PM

For that much modification, it is a BAD SCENE to not have a damper.
The heavier the better, even if you have to trim the front cross member a 1/4 inch.

03-28-2021, 06:08 PM	#22
Pete Senior Member Join Date: May 2010 Location: Wa. Posts: 5,421	Re: Crankshaft pulley - cast iron, steel or aluminum For that much modification, it is a BAD SCENE to not have a damper. The heavier the better, even if you have to trim the front cross member a 1/4 inch.