Quote:
Originally Posted by loubob
I purchased the LED bulbs from LedLight.com. After install they flickered every time I turned on the low beams but not on highs. Called Ledlight and was advised hat I needed to install a Load Equalizer to each headlight. They stated that because of the lower current draw, the system sensed it as a short/burned out bulb and was trying to compensate for it. The L.E's would "balance" the system. They stopped the flickering. I later installed a new wiring harness and it started all over again. On my last attempt I installed one LogoLite bulb and one Ledlight bulb and no flickering. I have no answer as to why that worked. LogoLite is going to replace their bulbs and I will try them or revert back to the one & one bulb and leave well enough alone.
I sincerely thank everyone for their advice and suggestions. Bob
|
Bob - thanks for the info. I have LEDs from both sources, and will try your suggestion tomorrow.
Thanks - Jim