08-25-2021, 09:28 AM
|
#9
|
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 5,849
|
Re: Gas Gauge Installation secret?
In a recent gas gauge discussion it was suggested to use two brass rings as the threads were bottoming out. https://www.brattons.com/brass-gas-g...ng-washer.html
Also some of the cheap aluminum "wrenches" don't fit well and make it difficult to tighten. I use this wrench set from Bratton's https://www.brattons.com/gas-gauge-tool.html and the holder https://www.brattons.com/gas-gauge-wrench-holder.html also from Bratton's without any issues. I use the cork gasket set and no sealant.
|
|
|