[epw1949]

Before heating and swapping your ring gear mark the location of you ring gear on your flywheel using your dowel pin holes for location.Now go to the flywheel your moving it to and by using the dowel pin holes locate the same location as the other flywheel,remove your ring gear with little heat, turn your ring gear a quarter turn,now heat it a little,and then it will fall on,make sure it seats all the way around against the flywheel.The reason you want to relocate the location of the ring gear,is your engine only stops at two locations,so when you start you engine its always at the one of the two locations on your ring gear.Hope this helps.E.P.W.