The Ford Barn - View Single Post - repairing rear axle housing bearing races..

Lowsquire · 11-23-2010, 06:22 AM

Sounds like a great way to go, especially if your needle roller bearings are toast as well, as they arent cheap either!
I would imagine a few minutes with a hub, and a vernier , and a good bearing catalogue would yield a workable combination..I think I need to ring some bearing Mfgs tommorow and get some catalogues sent out!
On This job I'll probably just use sleeves, as the bearings and outer races are perfect, but next one Ill try this out!

11-23-2010, 06:22 AM	#21
Lowsquire Member Join Date: May 2010 Location: Austin ,Texas Posts: 85	Re: repairing rear axle housing bearing races.. Sounds like a great way to go, especially if your needle roller bearings are toast as well, as they arent cheap either! I would imagine a few minutes with a hub, and a vernier , and a good bearing catalogue would yield a workable combination..I think I need to ring some bearing Mfgs tommorow and get some catalogues sent out! On This job I'll probably just use sleeves, as the bearings and outer races are perfect, but next one Ill try this out!