View Single Post
Old 07-07-2020, 08:41 PM   #20
1crosscut
Senior Member
 
1crosscut's Avatar
 
Join Date: Feb 2011
Location: Lincoln, Nebraska
Posts: 1,905
Default Re: Water in oil/engine

Sounds like a case of not checking torque as often as should have been after a new head installation. If the block is flat too then I would clean it up and put on a new standard copper gasket and torque through several heat cycles and then a few times after that as it is driven.
__________________
Dave / Lincoln Nebraska
1crosscut is offline   Reply With Quote