Quote:
Originally Posted by Robert/Texas
Thanks red & jb
I'll fill the two clamp surfaces with JB Weld. I'm 86 and don't offer any warrantees.
Thanks again, Robert
|
Why not just install the correct type clamps & rubber pieces, and modify the Vintique Wing Bracket?
All you need is a set of Pads; (
https://www.snydersantiqueauto.com/P...earchByKeyword)
-and a set of properly made Clamps; (
https://www.snydersantiqueauto.com/P...earchByKeyword).
Below I have included a picture of how to modify the 28/29 Bracket (grind a groove to accept the smaller bulged area of the rubber pad), and a picture of part of the factory blueprint that gives dimensions if you want to modify the repro bracket to the factory dimensions.