Re: Timing Help
Quote:
Originally Posted by Jbeavers
Hello, I have a 29 Model AA and recently had to replace the lower plate due to a bad wire, anyway had to redo the timing. I started with spark advance all the way up, found TDC on timing gear, used Nu-Rex wrench adjust and now truck only starts with spark advance lever all the way down. Do I start over? Perhaps I was not top dead center when i started? Im Assuming it’s way too advanced, sounds good when running with lever all the way down but I know that’s not right and looking for a little guidance.
Thanks
|
First, what are your points set at. Nu-Rex wrench doesn't work well if points are not set correctly ~.020. Sounds to me your are too far retarded if you have to advance the lever that far to get it started.
__________________
Ruth
"Sometimes you really DO need to read the whole thread"
Last edited by Ruth; 06-24-2020 at 12:55 PM.
|