Re: Cam and Quickchange question
Thanks guys!!... that would be great if it came from New England. I looked on the Isky website, but couldn’t find much info for Flathead cams. Just the Max #1 and a couple others. I’d like to get the numbers so I can keep a card with it. The QC does have bearings in it but they need to be replaced. I don’t see any trace of oil in it so I don’t know if it’s ever been used. I was told it would run Halibrand gears. I got no QC gears with it. I got a ‘38-24 stud block, oil pans for 59 style motors and most of what I was told was a ‘32 motor. I have to verify that with the block ID info that’s been posted previously. It has the same old story, was taken out of a running truck and taken a part 30 yrs ago to put in a SBC.
Thanks again..... Mark
__________________
I'm thinkin' about crankin'
My ragged ol' truck up
and haulin' myself into town.
Billy Joe Shaver
|