View Single Post
Old 10-29-2020, 12:32 PM   #38
JSeery
Member Emeritus
 
JSeery's Avatar
 
Join Date: Nov 2012
Location: Wichita KS
Posts: 16,132
Default Re: Finally some Cam Degree Numbers - Now what?

Quote:
Originally Posted by Bored&Stroked View Post
I kind of doubt that he needs to move it that much - he probably needs a "tweener" - something in the middle.
B&S
From Ross's original post on this topic:

"Side distributor timing set for 1/2 increment advance, like every other flathead I've had which was correct. Net is again 25 degrees advance at idle. Vacuum brake is screwed all the way in, but will still advance to about 35 degrees with RPM."

This is off quite a bit, sounds close to one tooth of the cam gear to me, maybe two.
JSeery is offline   Reply With Quote