The Ford Barn - View Single Post

George Miller · 01-28-2016, 02:04 PM

Did a little work on the engine. To cold and wet to paint it, so I worked on clutch. Drilled the chev flywheel for a Mustang pressure plate. Using a 9" clutch plate that fits the 39 Ford transmission. Made bushing for the end of the crank so I could use the ford A Pilot bearing. Reworked the chev V8 starter to fit the Ford block with the chev flywheel.

Firing order for those that were wondering. hits on 1 then 3 skip hits on 2 skip skip hits on 4

01-28-2016, 02:04 PM	#122
George Miller Senior Member Join Date: May 2010 Location: NC Posts: 2,975	Re: 5 main, chev, crankModel A engine Did a little work on the engine. To cold and wet to paint it, so I worked on clutch. Drilled the chev flywheel for a Mustang pressure plate. Using a 9" clutch plate that fits the 39 Ford transmission. Made bushing for the end of the crank so I could use the ford A Pilot bearing. Reworked the chev V8 starter to fit the Ford block with the chev flywheel. Firing order for those that were wondering. hits on 1 then 3 skip hits on 2 skip skip hits on 4 Last edited by George Miller; 01-28-2016 at 04:34 PM. Reason: added to