The Ford Barn - View Single Post

Track T-4 · 03-01-2019, 06:15 PM

I am installing the windshield crankout handle in the dash but do not have the part that holds the handle in place. Perhaps some kind of split ring? What is used? Is the part available, if so by whom?

Also, the shaft that the handle attaches to is high in the opening. Can this be adjusted? I'm a little reluctant to try prying it.

03-01-2019, 06:15 PM	#1
Track T-4 Junior Member Join Date: Oct 2012 Location: Maryland Posts: 19	'37 Ford windshield crank I am installing the windshield crankout handle in the dash but do not have the part that holds the handle in place. Perhaps some kind of split ring? What is used? Is the part available, if so by whom? Also, the shaft that the handle attaches to is high in the opening. Can this be adjusted? I'm a little reluctant to try prying it.