The Ford Barn - View Single Post - New gaskets

Tinker · 06-05-2020, 01:42 AM

You can get stock sheets of gasket material from napa, packs with cork and versions sizes and material. It's nice to have on hand if you do a service or want to replace certain little things. It takes a bit of time to cut out with a exacto knife and using a fuel line punch for holes. But not a big deal really. Depending on material a bit of oil or perm spray goes a long way. RTV gooping is overkill. In my thinking.

Looks like a good set of gasket you have. Don't over think it. Use them. Oil will get to them if they need it. Dry install.

06-05-2020, 01:42 AM	#19
Tinker Senior Member Join Date: May 2010 Location: MN Posts: 7,053	Re: New gaskets - cardboard You can get stock sheets of gasket material from napa, packs with cork and versions sizes and material. It's nice to have on hand if you do a service or want to replace certain little things. It takes a bit of time to cut out with a exacto knife and using a fuel line punch for holes. But not a big deal really. Depending on material a bit of oil or perm spray goes a long way. RTV gooping is overkill. In my thinking. Looks like a good set of gasket you have. Don't over think it. Use them. Oil will get to them if they need it. Dry install. Last edited by Tinker; 06-05-2020 at 01:48 AM.