View Single Post
Old 08-14-2015, 12:45 PM   #21
RonC
Senior Member
 
RonC's Avatar
 
Join Date: May 2010
Location: Rhode Island
Posts: 1,868
Default Re: electrical fuse problem

Quote:
Originally Posted by Y-Blockhead View Post
Is a 25 amp fuse large enough? Most of the Vendors provide a 30 amp fuse with the holder. I use a 30 amp ciruit breaker with no problem.

From Snyder's;
"A-11450-SF Safety Fuse Installation Instructions

Disconnect Battery! Bolt your safety fuse onto the engine side of the starter switch using the same screws that attach the switch. (Note: if the screws are too long and penetrate the starter body by more than 1/4” a short will result)

Remove the wire coming from the terminal box at the starter switch and attach it to the empty screw on the safety fuse.

Attach the yellow wire from the safety fuse to the bolt on the starter switch along with the battery cable. Replacement 30 amp fuses can be purchased at any auto supply store."
I use a 30amp but I have also used a 20amp with no problem
RonC is offline   Reply With Quote