View Single Post
Old 10-23-2020, 06:05 PM   #9
Senior Member
Bored&Stroked's Avatar
Join Date: Jan 2011
Location: Central Ohio
Posts: 2,893
Default Re: Finally some Cam Degree Numbers - Now what?

Originally Posted by JSeery View Post
Think I would stick a shim in between the lifter and the valve stem to get the valve lash out of the process.
Or, if you have "adjustables", just back out the adjuster until you feel it tight against the valve (when the lifter is on the heel of the cam). Even if you go a bit too far, you've taken up the slack.
Bored&Stroked is offline   Reply With Quote