View Single Post
Old 10-09-2020, 02:19 PM   #67
GOSFAST
Senior Member
 
GOSFAST's Avatar
 
Join Date: May 2010
Location: Long Island, NY
Posts: 1,052
Default Re: Question on Cam Gear Marks - UPDATE

Here's a link (https://www.fordbarn.com/forum/showt...reeing+pinning) to some interesting reading I put up here a while back!

We degree check EVERY cam we install on EVERY build and move them when necessary!

Thanks, Gary in N.Y.

P.S. If you look closely to the photo you'll notice a "timing-pill" installed in the Flathead gear, this allows us to "move" the cam from "+6* to -6*" if ever needed, the other photo is how the cam is degree-checked before the assembly!
Attached Images
File Type: jpg Flathead Timing Gear Pill B.JPG (81.6 KB, 30 views)
File Type: jpg Flathead Cam-Degree Checking Position B.JPG (59.6 KB, 31 views)

Last edited by GOSFAST; 10-09-2020 at 02:21 PM. Reason: C
GOSFAST is offline   Reply With Quote