The Ford Barn - View Single Post

tubman · 10-06-2021, 02:29 PM

Isn't the tire mounting surface 15" in diameter? If you account for the flange that holds the tire on, it's close to what I measured.

It's pretty hard to believe that I picked up an inch and a quarter by what I did to my springs (I did not have them re-arched). Unless we know what has been done to the Victoria pictured, it's hard to know exactly what's going on. Sevety tears of use can have it's effect.

10-06-2021, 02:29 PM	#12
tubman Senior Member Join Date: Dec 2013 Location: Minnesota, Florida Keys Posts: 10,328	Re: Measurement Needed 51 Vicky Isn't the tire mounting surface 15" in diameter? If you account for the flange that holds the tire on, it's close to what I measured. It's pretty hard to believe that I picked up an inch and a quarter by what I did to my springs (I did not have them re-arched). Unless we know what has been done to the Victoria pictured, it's hard to know exactly what's going on. Sevety tears of use can have it's effect.