The Ford Barn - View Single Post

CWPASADENA · 03-22-2021, 10:52 PM

Depends on which configuration you have.

In early to mid '30, the splash apron had a seam right at the front of the running board. The front part of the apron was actually spot welded to the front fender. The rest of the apron was part of the running board. The part of the apron that was welded to the front fender went under the front corner of the body.

Later in the '30 production (apx. Sept), the apron was one long piece and the front fender bolted to it at the front. The running board was a separate component. This design carried over into the '31 production.

Chris W.

03-22-2021, 10:52 PM	#5
CWPASADENA Senior Member Join Date: May 2010 Location: PASADENA, CA Posts: 1,885	Re: install front fender?? Depends on which configuration you have. In early to mid '30, the splash apron had a seam right at the front of the running board. The front part of the apron was actually spot welded to the front fender. The rest of the apron was part of the running board. The part of the apron that was welded to the front fender went under the front corner of the body. Later in the '30 production (apx. Sept), the apron was one long piece and the front fender bolted to it at the front. The running board was a separate component. This design carried over into the '31 production. Chris W.