The Ford Barn - View Single Post

100IH · 07-20-2020, 02:12 PM

Steve did you do the diagonal measurements? Just for grins do you have an old bare block. Put on the timing cover and front support yoke and install and look at where the stud on the yoke matches with the hole in the F. crossmember. That is just another indicator of Parallel issue but to the other side. Flying quails long ago.

07-20-2020, 02:12 PM	#7
100IH Senior Member Join Date: Dec 2011 Location: SW Idaho Posts: 970	Re: Frame to front and rear end alignment Steve did you do the diagonal measurements? Just for grins do you have an old bare block. Put on the timing cover and front support yoke and install and look at where the stud on the yoke matches with the hole in the F. crossmember. That is just another indicator of Parallel issue but to the other side. Flying quails long ago.