[mccsix]

Before I start ripping out wire here's my plan, if you see something wrong or missing pls let me know.

I have an alt not gen so delete the wire to cut out.

Attach wire to disconnected distrib steel cable then to one side of ign sw.
Run wire from ammeter to + coil, other side (-) ammeter goes to ign sw.

Run wire from starter, to left side j box term, then other term of ammeter to right side j box.
Run wire from starter to left side (+) j box
Run a wire from alt output to jbox (-)

I will tape the ammeter leads together to omit the gauge until I do a smoke check on my new rats nest