Quote:
Originally Posted by mccsix
Ok slowly but surely I'm diving in. The wire between ign sw and ammeter is gone, I notice how loose the 2 poles of the ammeter are to their case, removed the ammeter took it apart and the posts can touch the case, I know that's not right, also the needle is welded to gauge face.
Now whether all this caused or are the result of the overheat is ??
|
Remove the ammeter from the circuit! take the two wires that were connected to the ammeter and connect them together with a bolt or something, tape the connection so there is no chance of shorting, and then see if things still smoke, Just sayin!