The Ford Barn - View Single Post

Jazzjr · 11-13-2010, 11:59 PM

Fritz, I'm building my Huckster Van from a set of plans and Video from the Wagon Works. I don't know if yours was built from the same plans ??

I just Finished Building and installed My Front doors about a week ago, the Height is 45" Width is 27". Glass size is 24' wide by 18' high. If I get time Tomorrow I'll take some Photos and Post them to this Thread. Good Luck on Building the Doors, little bit tricky doing the Dadoing and making the Original or Repo's Window Risers and Glass Channel work, but mine came out Great, if I say so myself. The Rear Doors were a Breeze, even with Oval Windows.

For those looking to purchase the Plans and Video, His name is Jay Cramer. He bought out the Plans and business from the Hudson Wagon Works of years ago. His Address is below, best time to reach him is after 7 PM est.

Wagon Works
213 SW Kline St.
Ankeny, Iowa 50023-2639
Tel. 515-964-5085

11-13-2010, 11:59 PM	#15
Jazzjr Senior Member Join Date: May 2010 Location: Crown Point, NY and Punta Gorda, FL. Posts: 259	Re: Model A Huckster Group Fritz, I'm building my Huckster Van from a set of plans and Video from the Wagon Works. I don't know if yours was built from the same plans ?? I just Finished Building and installed My Front doors about a week ago, the Height is 45" Width is 27". Glass size is 24' wide by 18' high. If I get time Tomorrow I'll take some Photos and Post them to this Thread. Good Luck on Building the Doors, little bit tricky doing the Dadoing and making the Original or Repo's Window Risers and Glass Channel work, but mine came out Great, if I say so myself. The Rear Doors were a Breeze, even with Oval Windows. For those looking to purchase the Plans and Video, His name is Jay Cramer. He bought out the Plans and business from the Hudson Wagon Works of years ago. His Address is below, best time to reach him is after 7 PM est. Wagon Works 213 SW Kline St. Ankeny, Iowa 50023-2639 Tel. 515-964-5085 Last edited by Jazzjr; 11-14-2010 at 12:06 AM.