Quote:
Originally Posted by Mart
I'm assuming:
The axle is out.
All the bellhousing bolts are out, including the ones that go into the sump pan.
The gear linkages have been removed.
The clutch linkage has been removed.
The rear mounts have been removed.
The rear of the engine is supported under the sump pan.
You have 3" or so of clear space to allow rearward movement.
If all the above is correct, there is no reason why the gearbox shouldn't come out. It has to come out toward the rear. If it seems stuck to the engine try pressing the clutch lever. The action of the release bearing should push the gearbox off the engine.
If in doubt take some pics and post them up.
Mart.
|
I,v left two top bell housing bolts in place as the box needs to be stationary when the axle is pulled backwards ,??