[sugarmaker]

Ok guys,
The horn testing has me in a minor head lock. This may be just due to poor contact surfaces? Should I get a good continuity check across the two terminals in the horn? Just slightly confused due to lack of motor workings.
Just don't want to mess this up. So I have a 6 volt, positive ground Ford tractor setting here to test the horn.
Just want to wire up some test jumper wires.
So from the positive ground on the battery, to one side of the horn contact? Other side of the horn contact to the negative side of battery? Just touching any one of these contact point should be my switch??
Sorry for the electrical trivia.
Yes that works! I have functioning horn! Awesome!
Now to tune the sound a little also.
Regards,
Chris