The Ford Barn - View Single Post

19Fordy · 06-18-2016, 03:46 PM

If you bought the rubber separate from the sill plates the vendor may have supplied a little extra rubber so you won't be caught short. If you bought the sill plates with the rubber already installed I would think they are "correct" as is, but you never know. Make sure your windlace is in properly and then do some "trial fitting" before you make any cuts. Don't be in a hurry. Also, the door pushes against the rubber to seal the big air space at boor bottom.

06-18-2016, 03:46 PM	#10
19Fordy Senior Member Join Date: May 2010 Location: Coral Springs FL Posts: 10,921	Re: 1940 Ford scuff plates: If you bought the rubber separate from the sill plates the vendor may have supplied a little extra rubber so you won't be caught short. If you bought the sill plates with the rubber already installed I would think they are "correct" as is, but you never know. Make sure your windlace is in properly and then do some "trial fitting" before you make any cuts. Don't be in a hurry. Also, the door pushes against the rubber to seal the big air space at boor bottom.