Re: 1940 P/U WOC1 - Project
I started by making the box up first, With the help of the MV community I was able to gather up the info and detailed pictures to make drawings of the rear box and tool boxes. Lots of help from a couple of guys in England and Australia.
I did these drawings on a real simple IPAD program and had the pieces made up.
Getting the wood correct was a challange, I needed a finished 1" thick actual dimension, also I wanted a rough sawed looked to the wood as these boxes would have been made quickly and certainly not furniture quality. I scored big with rough fir, actual 1" thick dimension. The original would have been 1" thick tongue and groove material. THe millwork shop made up the panels and put a glued joint on each piece and then simulated the beveled edge of the T&G boards. Stronger than the orignal boards, yet look like the same.
Last edited by James Y; 03-02-2021 at 10:20 PM.
|