The Ford Barn - View Single Post - Floorboard

Russ · 01-17-2018, 07:42 PM

Thank you for the picture. This confirms that the rivet head is on the bottom. There also doesn't appear to be a washer between the clip and the upset end of the rivet. I don't think they would use a washer under the rivet head (head diameter is large), so either it was not used, or it is between the clip and the floorboard. If you just took this picture, is there anyway you can check, or at least look for a space between the sheet metal clip and the floorboard that would show a washer is under there?

01-17-2018, 07:42 PM	#4
Russ Member Join Date: May 2010 Location: Illinois Posts: 52	Re: Floorboard - Shift Lever Plate Clips Thank you for the picture. This confirms that the rivet head is on the bottom. There also doesn't appear to be a washer between the clip and the upset end of the rivet. I don't think they would use a washer under the rivet head (head diameter is large), so either it was not used, or it is between the clip and the floorboard. If you just took this picture, is there anyway you can check, or at least look for a space between the sheet metal clip and the floorboard that would show a washer is under there?