The Ford Barn - View Single Post

Los_Control · 07-31-2020, 03:32 PM

@mart that is good advice ... was your video I watched earlier when you removed your crusty crank, I think would be better off to get it rotating first if I can. And with a little effort I think it will.

@leon bee I may find same issue. Guy was asking $300 for engine/trans ... it did not sell and moved it out closer to his scrap pile. I offered $100 for it, I expected it to be junk, would need to buy a couple used engines to find something to build.
So I am still trying to prove myself correct, so far is a coin toss which way it goes.

07-31-2020, 03:32 PM	#29
Los_Control Member Join Date: Jan 2017 Location: West TX Posts: 58	Re: A few questions on a 8BA @mart that is good advice ... was your video I watched earlier when you removed your crusty crank, I think would be better off to get it rotating first if I can. And with a little effort I think it will. @leon bee I may find same issue. Guy was asking $300 for engine/trans ... it did not sell and moved it out closer to his scrap pile. I offered $100 for it, I expected it to be junk, would need to buy a couple used engines to find something to build. So I am still trying to prove myself correct, so far is a coin toss which way it goes.