View Single Post
Old 07-31-2020, 02:02 PM   #25
Los_Control
Junior Member
 
Join Date: Jan 2017
Location: West TX
Posts: 26
Default Re: A few questions on a 8BA

So a change of plans, While I still need to disassemble the engine, think I would be wiser to spend some time and see if can get it un-stuck first.
The cyl photo is the worst 2, I think they will clean up.

The last photo is where I think most of problem will be, crusty push rods from mouse pee. But there is only 2 or 3 that look bad. But cleaning up.



New plan is to leave the pan on, acetone/atf, diesel clean and soak everything.
Wash it all down into the pan.

Then actually put a breaker bar on it and see if it will turn. Only attempt to turn it over so far is by hand grabbing the crank pulley.
Starting to think if I get it unstuck, and cleaned up, it would probably run.
Assuming it does not have bad bearings/crank
Attached Images
File Type: jpg 0731201225.jpg (45.3 KB, 43 views)
File Type: jpg 0731201228a_Burst20.jpg (45.6 KB, 41 views)
File Type: jpg 0731201229.jpg (54.1 KB, 41 views)
File Type: jpg 0729200938a.jpg (187.4 KB, 40 views)
File Type: jpg 0731201047b.jpg (148.1 KB, 38 views)
Los_Control is offline   Reply With Quote