Re: Brattons Radiators
Report I saw mentioned mounting holes/tabs did not line up, and some drilling was required. Reports surfaced when I was researching when replacing my old radiator. Reports were old, years old. Never heard/saw if the issues were fixed. But is why I went with Bergs, have yet to hear of any complaints/issues on Bergs - drop in replacement.
As far as function/cooling - I saw/heard no issues with the Brassworks. Brassworks uses Ford prints to make theirs so can be used on fine point cars.
My Bergs is working beautifully, have to run a 160 F thermostat when temps below 80 F, otherwise coolant does not get up to operational temp.
|