Quote:
Originally Posted by 31 RPU
I have a Boyce motor meter made for a model A to mount on steering column.
It has a sensor, that I was told mounts in a hollowed out head bolt. Is this correct? Could the head bolt still be torqued if it is hollow? Does anyone have one they would sell?
|
This is a picture that Joop posted in the past.
In it, you can see clearly how the bolt was made. I would think a machine shop could make one up for you. I'm not nearly good enough on using my lathe to volunteer. Tom how about you, up to the challenge? Have any hex stock hanging around?