The Ford Barn - View Single Post

MAG · 07-07-2017, 03:00 PM

I have one but can't get to it right now. Not for sale.
It is about 3 1/2" tall. Made from 11/16" or 3/4" hex stock.
Only the top is hollow. About 1 1/2'" deep to accommodate the sensor.
Bottom is drilled and tapped to fit the original head stud.
The top is threaded to allow the sensor to be attached.
It can be torqued.
A machinist could make one.

07-07-2017, 03:00 PM	#2
MAG Senior Member Join Date: May 2010 Location: Austin, Texas Posts: 925	Re: Boyce Moto Meter Head Bolt for sensor I have one but can't get to it right now. Not for sale. It is about 3 1/2" tall. Made from 11/16" or 3/4" hex stock. Only the top is hollow. About 1 1/2'" deep to accommodate the sensor. Bottom is drilled and tapped to fit the original head stud. The top is threaded to allow the sensor to be attached. It can be torqued. A machinist could make one. __________________ I noticed the harder I work the luckier I get!