The Ford Barn - View Single Post

Tom Morookian · 06-19-2011, 05:37 PM

I took an old aluminum license plate and cut strips about 1/4 wide and 1" long. Bend one end into a T shape just big enough to slide into the molding. Cheap and easy. Any piece of aluminum around 20 guage should work. On the back side you can twist them or just bend them over.

Nobody makes the clips that fit.

06-19-2011, 05:37 PM	#3
Tom Morookian Senior Member Join Date: May 2010 Location: N. Ft. Myers, Fl. Posts: 502	Re: !936 Ford Spare Tire Cover I took an old aluminum license plate and cut strips about 1/4 wide and 1" long. Bend one end into a T shape just big enough to slide into the molding. Cheap and easy. Any piece of aluminum around 20 guage should work. On the back side you can twist them or just bend them over. Nobody makes the clips that fit.