View Single Post
Old 08-26-2019, 09:51 AM   #9
Badpuppy
Senior Member
 
Join Date: Dec 2017
Location: Guthrie, OK
Posts: 1,141
Default Re: Cowl light wire routing behind cowl panel

The wire passes between the left frame rail and frame extension (floorboard support). Not much space, but enough. I believe the single un-loomed wire is run here (under the engine mount) and connects to the harness. This wire can be clipped to the rail with the rear loom. Originally there was a ceramic or bakelite connector housing clipped to the left frame rail, but modern harnesses have a bullet receptacle. Inside, the loom runs across the firewall, supported by three clips. Two attach to the screws holding the hood lacing at the sides, the third to the upper-left screw of the junction box.

You can also run the loom part forward and support the single wire inside with the rubber grommets included with the supports sold by the vendors.
Badpuppy is offline   Reply With Quote