Re: Light Switch / Horn Rattle
I also had a rattle in the horn rod assembly.
I had installed the bushing.
It would stop when I put my finger on the light switch lever.
I finally figured out that the light switch piece that also holds the horn button was loose on the rod.
I was able to remove the horseshoe shaped retaining clip on the bottom of the rod and pull the rod up enough the remove the horn button retainer. Then I could re-swaged the horn rod tube to tighten the top part so it was no longer loose. I think I even used a little JB Weld just to make sure.
Now everything is nice and quiet.
That is what I found and how I fixed it.
Chris W.
|