The Ford Barn - View Single Post - Do You Have A Chassis Engineering Mustang II Front Kit You Haven't Installed Yet?

cbillelder · 01-23-2018, 05:09 PM

Hi Guys-
I'm looking for some help here. I have a Mustang II front crossmember made by Chassis Engineering that I want to install in my '36 Ford frame. Unfortunately, the rear brackets for the lower arm strut rods were lost, so I'm going to have to make them since Chassis Engineering is out of business. I have another '36 Ford here with that setup that I can get most of the measurements from, but I need to know what the hole size is in the brackets that the strut rod rubber bushings mount thru. If you have one of these kits you haven't installed yet, could you measure the diameter of that rubber bushing hole for me? I would appreciate it very much. It doesn't matter what car your kit is made for. As long as it's a Chassis Engineering kit, I'm sure the bushing holes are all the same size. If not, do you know someone who has one? Please let me know if you do. PM me or email me at [email protected]
Thanks guys,
Bill

01-23-2018, 05:09 PM	#1
cbillelder Senior Member Join Date: May 2010 Posts: 961	Do You Have A Chassis Engineering Mustang II Front Kit You Haven't Installed Yet? Hi Guys- I'm looking for some help here. I have a Mustang II front crossmember made by Chassis Engineering that I want to install in my '36 Ford frame. Unfortunately, the rear brackets for the lower arm strut rods were lost, so I'm going to have to make them since Chassis Engineering is out of business. I have another '36 Ford here with that setup that I can get most of the measurements from, but I need to know what the hole size is in the brackets that the strut rod rubber bushings mount thru. If you have one of these kits you haven't installed yet, could you measure the diameter of that rubber bushing hole for me? I would appreciate it very much. It doesn't matter what car your kit is made for. As long as it's a Chassis Engineering kit, I'm sure the bushing holes are all the same size. If not, do you know someone who has one? Please let me know if you do. PM me or email me at [email protected] Thanks guys, Bill Last edited by cbillelder; 01-23-2018 at 05:24 PM.