Quote:
Originally Posted by deuce_roadster
I agree with post 51. Cam and crank are not in synch. Picture by OP not good enough to tell if it is correct and I don't think it is.
|
I dont understand how it could be out of time when you take the timing cover off and make sure the cam gear slash and the crank gear dot meet at 6 and 12 oclock. Put the timing cover back on and the needle and the pully Dot meet dead on as well as well. Then you pull the cap and the rotor is pointing directly at the #1 plug wire and then you check the order of the wires 5 times and they are correct to the firing order on the cap and meet the correct plug holes. And then you pull a #1 plug and rotate the engine till you see spark on the plug end and stop immediately and pull the cap again and the rotor is on #1 plug wire again. I ask then how could it be out of time? What then am i missing?