Sponsored Links (Register now to hide all advertisements)
Quote:
Originally Posted by Seabees
Howdy boys, reckon I'll ask this group also. What size reamer do I use for the following; King pins, rear brake cam, oil pump, dist., front brake actuators, and brake and clutch pedal? Thanks guys!
|
You are asking a very loaded question since the quality of finish is directly related to the type of reamer used, the quality of the reamer, and how the reamer will be rotated (power vs. hand). None the less, the
finished sizes that you are asking for are as follows;
....Oil Pump 0.4990"
....Distributor Shaft 0.5015
....Brake Actuator 0.5575"
....Rear Brake Cams 0.6890"
....King Pin 0.8140"
....Pedal Shafts 0.8755"
....Piston Pins 0.9905"
....Sector Housing 1.1245
Again, these are not reamer sizes but finished sizes. In the perfect world, you mic the different shafts of the items you are wanting re-bushed, and then set your clearances accordingly.