The Ford Barn - View Single Post

JWL · 08-25-2020, 08:58 AM

I do not see any way to do a bore/hone without pistons in hand?? Also, who is going to supply the valves for the valve job? Who is going to check the rods for alignment? How will the pins get fitted? Just to name a few things.

08-25-2020, 08:58 AM	#4
JWL Member Emeritus Join Date: May 2010 Location: Fitzgerald, Georgia Posts: 2,204	Re: Engine Shop Expectations (Flathead 8ba) I do not see any way to do a bore/hone without pistons in hand?? Also, who is going to supply the valves for the valve job? Who is going to check the rods for alignment? How will the pins get fitted? Just to name a few things.