The Ford Barn - View Single Post

Bruce of MN · 09-23-2020, 06:06 AM

You ought to consider a Mitchell overdrive. I installed mine this spring by myself, except for getting a neighbor to help push the u-joint onto the trans output shaft. It truly was a bolt-in.

09-23-2020, 06:06 AM	#3
Bruce of MN Senior Member Join Date: May 2010 Location: VA Posts: 1,410	Re: T5 Valley Machining Kit You ought to consider a Mitchell overdrive. I installed mine this spring by myself, except for getting a neighbor to help push the u-joint onto the trans output shaft. It truly was a bolt-in.